Manitowoc I0320 Specifikace stáhnout pdf (Strana 49)

Part Number STH025 2/14 49

D. Remove the ice thickness probe

• Compress the hinge pin on the top of the ice

thickness probe.

• Pivot the ice thickness probe to disengage one pin

then the other. The ice thickness probe can be

cleaned at this point without complete removal. If

complete removal is desired, disconnect the ice

thickness control wiring from the control board.

E. Remove the water distribution tube

NOTE: Distribution tube thumbscrews are retained to

prevent loss. Loosen thumbscrews but do not pull

thumbscrews out of distribution tube.

• Loosen the two outer screws (do not remove

screws completely they are retained to prevent

loss) and pull forward on the distribution tube to

release from slip joint.

• Disassemble distribution tube by loosening the two

(2) middle thumbscrews and dividing the

distribution tube into two pieces.

Proceed to page 45, Step 7

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 271 272

Žádné komentáře

Manitowoc I0320 Specifikace Strana 49