Manitowoc QM20 Series Servisní příručka

QM20 Series Ice Machine Installation, Use and Care, and Service Manual Thank you for selecting a Manitowoc Ice Machine, the dependabil

Installation Instructions Section 22-4 ELECTRICAL CORD STRAIN RELIEF To prevent strain at the electrical connection inside the ice machine, an ele

Section 2 Installation Instructions2-5Water Service/Drains WATER SUPPLY Local water conditions may require treatment of the water to inhibit scale

Installation Instructions Section 22-8 ROUTE ICE MAKING WATER INLET TUBING THROUGH ICE MACHINE AND CONNECT TO WATER INLET VALVE ICE MAKING/BIN

Section 3 Ice Machine Operation3-1 Section 3 Ice Machine Operation Sequence of Operation Control Board Relays Ice Making Sequence of Operatio

Ice Machine Operation Section 33-2 Ice Thickness AdjustmentQM-20 dice ice cube formation is slightly different from our previous models. Manitowo

4-1 Section 4 MaintenanceSection 4 MaintenanceInterior Cleaning and SanitizingGENERAL You are responsible for maintaining the ice machine in accord

Maintenance 4-2 Section 4Step 4 Wait until water flows over the evaporator (about three minutes) then add the proper amount of Manitowoc Ice Machine

4-3 Section 4 MaintenanceParts Removal Overview WATER TROUGH OVERFLOW TUBE WATER DISTRIBUTION TUBE WATER PUMP AND BRACKET ASSEMBLYWA

Maintenance 4-4 Section 4B. Remove the Overflow Tube • To remove the tube, lift it up while using a slight back and forth motion to loosen it from

4-5 Section 4 MaintenanceStep 7 Mix a solution of cleaner and warm water. Depending on the amount of mineral buildup, a larger quantity of solution

Safety Notices When using or servicing a QM Series Ice Machine, be sure to pay close attention to the safety notices in this manual. Disregarding the

Maintenance 4-6 Section 4 WARNING Disconnect electric power to the ice machine at the electric switch box before proceeding. Step 17 Repeat step 6

4-7 Section 4 MaintenanceCLEANING THE CONDENSER WARNING Disconnect electric power to the ice machine at the electric service switch before cleani

4-8 Maintenance Section 4Removal from Service/Winterization GENERAL Special precautions must be taken if the ice machine is to be removed from serv

Section 5 Before Calling for Service5-1 Section 5 Before Calling for Service Checklist If a problem arises during operation of your ice machine,

Before Calling for Service Section 55-2 Problem Possible Cause To Correct Ice machine produces shallow or incomplete cubes, or the ice fill patte

MANITOWOC ICE, INC. 2110 South 26th Street P.O. Box 1720 Manitowoc, WI 54221-1720 Phone: (920) 682-0161 Fa

Table of Contentsi Table of Contents Section 1 - General Information Model/Serial Number Location ...

Table of Contents ii THIS PAGE INTENTIONALLY LEFT BLANK

Section 1 General Information1-1Section 1 General Information Model/Serial Number Location Record the model and serial number of your ice machine

General Information Section 11-2 Owner Warranty Registration CardGENERAL The packet containing this manual also includes warranty information. War

Section 2 Installation Instructions2-1Section 2 Installation Instructions Dimensions 55.93 cm (22.02”) 76.20 cm(30.00”)38.10 cm(15.00”) SV1717

Installation Instructions Section 22-2 Location of Ice Machine The location selected for the ice machine must meet the following criteria. If any

Section 2 Installation Instructions2-3Electrical ServiceGENERAL WARNING All wiring must conform to local, state and national codes. WARNING